IOT weather station using DHT11 | DIY | Blynk

Published: 11 September 2020
on channel: NematicsLab
2,533
109

$2 for 2-Layer PCBs & $5 for 4-Layer PCBs: https://jlcpcb.com

More project information(Code,Schematic,etc):- https://nematicslab.com/diy-iot-weath...

To add esp8266 boards in Arduino IDE software: https://nematicslab.com/install-esp82...

Website,
https://NematicsLab.com

Patreon,
  / nematicslab  

For Sponsorships or Endorsements ONLY!
[email protected]

For project-related questions use Facebook or Twitter @NematicsLab

Music used in the video:
1) Manhattan by Dyalla
2) Midnight Prophet by Sarah, The Illstrumentalist

--------- Affiliate ---------

Gearbest- http://bit.ly/2KD54KD
Banggod- http://bit.ly/2xgJIK5
LCSC - http://bit.ly/2KD0hJ0

--------- Social Media ---------

Facebook - http://bit.ly/2FC5lJz
Instagram - http://bit.ly/2XddQpe
Twitter - http://bit.ly/2IUhqMm

-------------------Electronics Starter kit Tools-------------------
Soldering Iron - https://www.banggood.in/custlink/DKGK...
Solder wire - https://www.banggood.in/custlink/mv3v...
Helping Hands - https://www.banggood.in/custlink/vmvm...
Hot Glue - https://www.banggood.in/custlink/D3GD...

---------------Little information about Video------------------
This project is related to initial steps in IoT world, here we will interface DHT11/DHT22 sensor with NodeMCU or other ESP8266 based board and receive data on internet we are going to use Blynk application, use the following tutorial link if you are not familiar with blynk application.

For Blynk (it require only few minutes): https://docs.blynk.cc

After this you are require to add esp8266 boards in your Arduino IDE software, use following link

There are simple hardware connections, you are not going to deal with any messy connections, so recreate & enjoy this project.


Watch video IOT weather station using DHT11 | DIY | Blynk online, duration hours minute second in high quality that is uploaded to the channel NematicsLab 11 September 2020. Share the link to the video on social media so that your subscribers and friends will also watch this video. This video clip has been viewed 2,533 times and liked it 109 visitors.