Flow sensor FM-HL3012 - датчик расхода жидкости

Опубликовано: 27 Март 2020
на канале: hi-ip.com
625
10

Features:

Food grade POM (polyformaldehyde) material, environmental friendly material, small, flexible and functional.
Intubation design of inlet and outlet pipe, easy connection and operation.
Small size, light weight, self-assembled in four directions, easy to install
High flow accuracy, good reliability and long life
Compliance with safety standards, Rohs, FDA requirements

Application:
Water heater, washing machine, boiler, electromagnetic water heater, water dispenser, water purifier, R.O. machine, U.F. machine, coffee machine, water machine, water machine control, water control machine, beer machine, beauty equipment, shower equipment, electrolytic water machine, energy engineering, heat pump,IC meter, steam equipment, irrigation equipment, water system, campus card self-service sale (sell) water machine, washing machine, automatic washing equipment, water treatment equipment, water dispensing equipment, cooling system, circulation system, intelligent toilet (toilet), bidet, mechanical equipment, heating equipment, Pharmaceutical (agents) equipment etc.

Specification:
Calculation Formula: F(Hz)= 76 x flow rate(Q)(l/min)
Flow range: 75ml-570ml/min
Measurement accuracy: +/- 3.0%
Temperature range: -10 to 65 ° C
Pressure range: -10 to 0.3 Bar at 20°C
Power supply voltage: +3.8 to +20 VDC
Signal connection: NPN transistor open collector
Signal voltage: VDC GND
Connection terminal: PANCON MAX-CON 156MLSS
Output signal: square wave
Duty cycle: ~50%
Rated voltage and current: DC5V, no more than 8mA
Output voltage: (rated: DC 5V); High level 4.5V and above; low level 0.5V and below
Pulse output duty cycle: 50+-10%
Insulation resistance: 100M Ohm and above
Tightness: Seal up all the holes, and inflate with 0.8MPa water, after 1 minute, no leakage and deformation.
Working Pressure: under 0.8Mpa
Electrical Strength: AC500V 50Hz
Material: Food grade POM (polyformaldehyde)
Dimensions: 56x50x35mm/2.2x1.97x1.38inch



Note:
1. When magnetic material is close with the sensor,its characteristics may vary.
2. In order to avoid particle debris, the sensor must beinstalled after a filter.
3. The flow sensor installation has to avoid strong vibration and shaking of the environment, so as not to affect the sensor's measurement accuracy.

Viber:
050 9670274

Купить:
https://hi-ip.com/en/industrial-autom...


Смотрите видео Flow sensor FM-HL3012 - датчик расхода жидкости онлайн, длительностью online в хорошем качестве, которое загружено на канал hi-ip.com 27 Март 2020. Делитесь ссылкой на видео в социальных сетях, чтобы ваши подписчики и друзья так же посмотрели это видео. Данный видеоклип посмотрели 625 раз и оно понравилось 10 посетителям.