VMUS O3 Generator Flowmeter and Flow Switch Operation
This video shows how to operate the flowmeter and flow switch on the VMUS-4 Ozone Generator.
The VMUS-4 Ozone Generator can be plugged in and left in standby mode for as long as needed. It will remain in standby mode until the flow of dry air or oxygen activates the VMUS-4 to produce ozone. The oxygen in this video is being produced with an oxygen concentrator. The O2 gas flows from the O2 generator outlet to the VMUS-4 Ozone Generator inlet through ozone resistant tubing.
The flowmeter screen on the VMUS-4 shows the amount of oxygen flow entering the inlet on the VMUS-4 Ozone Generator. The number on the screen stays the same when the oxygen flow remains steady, and changes if the O2 flow increases or decreases. The amount of oxygen flow is controlled by the flowmeter on the oxygen generator.
When the oxygen flow is below 0.2 LPM, no ozone is produced. When the oxygen flow increases to 0.2 and above, ozone is produced.
Pressing the UP arrow increases the ozone production level. Pressing the DOWN arrow reduces the amount of ozone being produced.
Pressing the "ON/OFF" button will power the VMUS-4 O3 Generator off. The O2 flow will not activate ozone production if the VMUS-4 is powered off.
Purchase VMUS-4 Ozone Generator here:
https://www.oxidationtech.com/vmus4.html
Watch video VMUS O3 Generator Flowmeter and Flow Switch Operation online, duration hours minute second in high quality that is uploaded to the channel Oxidation Tech 19 November 2020. Share the link to the video on social media so that your subscribers and friends will also watch this video. This video clip has been viewed 310 times and liked it 2 visitors.
