Cut-Off tool, Gear Hobs, Grinder Dust Collecting and a Funky Old Drill Press

Published: 27 September 2024
on channel: Winky's Workshop

5,578

766

A recap on my Cut-off tool and plans for future videos - Including a 1918 friction Drill Drill Press

LINK to Previous Video on Cut-off Tool:
• Spring Cut-Off, A near perfect soluti...

Link to the cut off blade used: https://amzn.to/3YV6qWn

Link to measured drawings of this tool - REV. 3 (Includes AXA and both Dorian and Non-Dorian BXA Drawings)

https://drive.google.com/file/d/1xuM8...

NOTE FOR USING:

1) The feed rate I used was .0018 per turn and it seemed to work well.
2) RPM is set for the surface speed of the full diameter (very forgiving)
3) The tool angle was set to about 3-4-degrees in all my tests and it worked well (experiment)
4) Tool was grounds to about 5 or 6 degrees
5) The blade Stick-out needs to be 3/4" to 1" *
6) Oil is a must. The little needle tip bottle like I used in the video is ideal.

I know this seems counterintuitive but it works. When the blade is shorter it effects the amount of pressure needed to deflect the blade and it chatter.

Watch video Cut-Off tool, Gear Hobs, Grinder Dust Collecting and a Funky Old Drill Press online, duration hours minute second in high quality that is uploaded to the channel Winky's Workshop 27 September 2024. Share the link to the video on social media so that your subscribers and friends will also watch this video. This video clip has been viewed 5,578 times and liked it 766 visitors.

48,459

952