How to use touch sensor with Arduino Uno in Burmese/Myanmar
This video is for educational purpose.In this video i am using touch sensor to give signal to relay to control 12VDC light bulb for testing safety purpose. (note; Relay load side is optional either Ac220v Or DC -6 to 30v according to what type of relay you using).
Parts;
Arduino Uno R3
Bread Board
Touch Sensor
5V relay board
Jumper wire
Connetion;
Uno Vcc - Bread board + holej(positive)
Uno Gnd - Bread board - hole (negative)
Sensor Vcc -Bread boad + hole (positive)
Sensor Gnd - Bread board - hole (negative)
Sensor out - Uno digital pin 2
Relay Vcc -Bread boad + hole (positive)
Relay Gnd - Bread board - hole (negative)
Relay Trigger - Uno digital pin 3
Download the code here
https://github.com/passion-tech/Hello...
Watch video How to use touch sensor with Arduino Uno in Burmese/Myanmar online, duration hours minute second in high quality that is uploaded to the channel Passion Tech KLM 03 April 2020. Share the link to the video on social media so that your subscribers and friends will also watch this video. This video clip has been viewed 152 times and liked it 8 visitors.
